So I am enjoying my new Toy, and a few questions have popped up.

I am still in the process of copying files over, so I am not up to speed on all the option yet.

config: (4 drives configured for raid 0)
drive 1 : 250gig (WD)
drive 1 : 3TB (seagate)
drive 1 : 2TB (seagate)
drive 1 : 3TB (seagate)

Ok, so at some point, I am going to want to swap out the 250gig and put in another 3TB drive

From what I have read so far online, is I will need to pull the drive, re-run the wizard and then run the repair/discovery process for it to re-add the larger drives.

Is this correct?


------------------------------------------------------------------------------------------------

also, I have not been able to find this, but its killing me the number of shares that are being set on volume1. I want to delete some of them, but I cant seem too.

is there a trick to cleaning up some of these?


also, created a user called "stephen" and I see a share called Stephen. I cant seem to find anything that describes what that share is for, and what not.



any insight would be nice.