Junior Member
Patriot Infernus 60GB slow speeds
HI all, i got this SSD and seems to be slower than is suppose to be, here is an ATTO capture
My specs
CPU Intel Q9550
Motherboard DFI LANParty DK P45-T2RS Plus
Gskill f2-6400cl4s-1gbpk x4
Xfx HD5770
Antec true power trio 480 w
Win7 64 bit
Patriot inferno 60gb latest firmware (updated yesterday)
indeed after the upgrade seems to be slower. Any ideas?
Junior Member
Don't quote me, but i think u need to wait 24hours after you do Firmware update to get a more accurate reading.
Junior Member
OK I will have in mind that, thx for the tip and waiting for new reply
Junior Member
Well i got a mayor problem now, my motherboard stops to recognizes the SSD, if i plug it on another mother is seams to be ok, but now on my DFI the bios don`t see it any more. I try to clear cmos by jumper, even removing the battery but do not work, any ideas?
Super Moderator
The low readings would probably be cause by the drive being in IDE mode instead of AHCI mode. Also, your mainboard does not support SATA 6.0gb/s aka SATA III.
I am unsure why your mainboard would stop recognizing the drive, while other systems do so fine. Double check the SATA cable (and swap it if needed) and verify the power connector has power.
I AM NOT A PATRIOT MEMORY EMPLOYEE.
But they have, on occasion, bribed me with hardware.
I am happy to help, but don't PM me. Post a thread in the appropriate forum so others may benefit and offer assistance.
Your lack of planning is not an emergency on my part.
Junior Member
No, is always in AHCI mode. Before the fw update seem to be faster, I do not think that is a SATA type problem, sata 2 reach 250-300mb/s and sata 3 600mb/s and this ssd is on 180 mb/s, then do not think this is the problem.
I already use another sata cable, and use an independent power supply but is the same.
Even I flash my motherboard to a previous version and do not work, then I flash it again to the last version and still the same issue.
Posting Permissions
Reply With Quote