Firmware 3.3.2 is here!

[Mseirco]

Ok whit 5.0.1 firmware i got allready 3 bsod blue screen reboot. Now i try whit the 3.3.2 firmware.

[Patriot_Ben]

Can you verify if the firmware flashed successfully? It is not recommend to go back. Once the drive is flashed to 5.0.1, the controller tunes the drive for the latter firmware sort to speak.

When are these reboots occurring? Is it random? Only after benchmarks? Can you try reflashing it again?

Do you have all of your latest drivers installed? Please try applying them if it is not.

[Mseirco]

hello.

I have all latest drivers installed for my motherboard yes.

Now im on 3.3.2 and i dont have bsod issu for now. i look for seven day if i got another bsod i tell you quickly!

When i get bsod whit firmware 5.0.1 is every time in cristal disk mark benchmarking!

[Mseirco]

Hello. just for keep you informed, whit the 3.3.2 firmware, until now, i dont get any BSOD for now. Before whit the 5.0.1 i got quickly 3 BSOD!

Then, i think the 3.3.2 firmware is the best one!

I keep you informed!

EDIT: this is my score on crystal disk mark, http://imageshack.us/f/832/benchfirmware302.png/

Patriot wildfire 120go model. Is not too much 480mo on writing data?? lol

[Patriot_Ben]

High 400 MB/s read & write is actually pretty good for the Wildfire. The 500+ speeds are usually measured using ATTO, which will always be higher than Crystal Disk Mark. This is the case because Crystal Disk Mark measures compressed data and ATTO measures uncompressed data.

[Mseirco]

Yes. i just tryed ATTo and i get 500+ ! Now i only hope i not got another BSOD..

Very strange, 3.3.2 firmware loooking much better than 5.0.1 ...

[Mseirco]

Hello, just for let you know, whit the 3.3.2 firmeware i get some "SSD drive disconnected" message from my RSTE drivers. Than now im running again whit the latest firmeware 5.0.1 . For now everything work fine. Hope so!

[Mseirco]

Ok, whit 5.0.1 firmware everytingh is stable excepted some ""SSD drive disconnected/reconnected"" message from my RSTE driver. This is normal?

[Patriot_Ben]

Ok, whit 5.0.1 firmware everytingh is stable excepted some ""SSD drive disconnected/reconnected"" message from my RSTE driver. This is normal?

Can you elaborate more on this? When does this occur? Is it random? So, this happens when you're not disconnecting or connecting?

The RSTE should make hot-swapping more seamless.

[secretanchitman]

hey guys! new the forum but i have lurked since last year! just had a quick question...

i have a day 1/july 2011 patriot wildfire 240GB ssd that ive used in my 2011 15" macbook pro without issue! absolutely fine in every way. i am not sure which exact firmware its on but its definitely launch firmware. i wanted to update to 3.3.2 but if im having no issues, should i not worry about it?

thanks a lot!