Only as an unbricking attempt.
does not work,
the hyper screen is keep running
Do you have any idea to fix my PBO box?
Check your wires and connections. I am using some pins to connect the USB-TTL cable to the newer version of PBO. Sometimes the connection is not good and it will show the same non-stop message in hyperterminal. I have to turn it off, reconnect the pins and cable to get it to work.
question: in PBP board, There are 2 are have TTL connection,
and I used one on the side near the fan, My board no respond to any key board press
Go back to the first page of this thread and make sure you have wires in the correct order. I am using a 3-wire version, so I have no vcc and leave the second pin empty.
No Input Vcc require? The Second pin you meant VCC?
Would you take image shot of your TTL board?
I can not believed it, any Eprom or Flash memory need Voltage to turn on.
The Flash memory got vcc from AC adapter when plug in.
Hope this clarify your doubts.
EDIT: Just to add a little bit, the VCC connection (RS232 TTL teerminal) on the PBO is an output (+5Vdc) not an input.
Last edited by snappy46; 09-12-2011 at 07:18 PM.