Issues in playing blu-ray file

[malathan]

Took my "Cars" blu-ray and tried to put it on the PBO. Using AnyDVDHD, I did an ISO rip to hard drive. From this ISO, PBO played fine with 4 audio channels, but NO chapters. I then mounted ISO and used MakeMKV 1.42 to convert to mkv, selecting only the movie and all audio channels. Result was 31 chapters were present, it showed 4 audio channels, but the first 2 channels were unplayable.

Audio Channels:
1) LPCM - Linear PCM - 6 channels
2) Dolby Digital - 6 channels
3) Dolby Digital - 2 channels (directors discussing movie)
3) Dolby Digital - 2 channels (directors discussing movie)

What am I doing wrong? Is it something I am doing or the PBO?

[malathan]

Anyone have any ideas/thoughts?

[MaxBurn]

There is no menu or chapter support yet, they are saying soon (tm) on getting a firmware that can do that. You get fast foreward rewind and the ability to change files if you are in file mode. If an iso i think it just picks the largest file in there and plays that assuming it is the movie.

Are you trying to play it over a network? Check the network speed thread for that.

[malathan]

From usb drive.

What I don't understand is why is there chapters in the mkv file, but not the iso? Furthermore, why does the 2 primary audio tracks play in the iso, but not the mkv. Figured it is something on my end that I am doing, but cannot figure it out.