Minor Torqx Jumper Question

[Dreven]

The drive I got had the newest firmware. I didn't even look at the jumper. Can anyone tell me if there's room in the jumper area to hang the included jumper (like hang it off a single pin without actually closing two pins)?

My Antec 900 case is freaking cramped (seriously - loved it when I bought it, now I can't stand it because doing anything inside it without taking the whole thing apart is a cramped pain in the rear end). If there is space to "hang" the jumper, I'll pull it out and place it on a pin so I won't loose it. Otherwise I'll avoid going into the case.

Thanks :)

[nate42nd]

There is plenty of room there to "hang" it from one pin. I don't know if it's a good idea or not, but the room is there. I would just tape it to the drive instead. Better yet have a small matchbox (mine came with one) in the case and put some extra screws, etc, and the jumper in the box. That's my thought of the day. Have a good one.

[Patriot_Ben]

The drive I got had the newest firmware. I didn't even look at the jumper. Can anyone tell me if there's room in the jumper area to hang the included jumper (like hang it off a single pin without actually closing two pins)?

My Antec 900 case is freaking cramped (seriously - loved it when I bought it, now I can't stand it because doing anything inside it without taking the whole thing apart is a cramped pain in the rear end). If there is space to "hang" the jumper, I'll pull it out and place it on a pin so I won't loose it. Otherwise I'll avoid going into the case.

Thanks :)

Dreven,

If you can manage to get the metal part in the jumper to touch the pins it should work. It doesn't necessarily need to be pushed in all the way.